ZSSC313XBOARDV1P1S

ZSSC313XBOARDV1P1S Features

different digital interfaces of IDT SSC ICsInterface to the user’s computer via a USB port via the SSCCB, which is also included in IDT’s modular SSC EvaluationKitsaddressable separately via one SSC CB, allowingsimultaneous calibration of up to 192 DUTs with one systembus is possiblevia USB interface – simple, low costEvaluation Kits – simple installation.

ZSSC313XBOARDV1P1S Description

The SSC Mass Calibration System (MCS) enables simple andintuitive handling of calibration and evaluation of a larger numberof sensor systems based on IDT’s Sensor Signal Conditioner ICs(SSCs). An evaluation of different mass calibration procedures forsubsequent series production is possible earlier in the productdevelopment phase. This allows an optimized product design thatcan meet the requirements of cost-effective mass manufacturingand mass calibration.The primary circuit board for the MCS is the Mass Calibration Board(MCB), which communicates with the user’s computer via the SSCCommunication Board (SSC CB). For each MCB, up to 24 devicesunder test (DUTs) can be calibrated, and up to eight MCBs can beconnected in series to a single SSC CB, allowing mass calibrationof up to 192 DUTs.Three digital interfaces are supported: I2C, one-wire interface(OWI), and Local Interconnect Network (LIN)*. The analog outputvoltage of each DUT can also be monitored and measured. Theuser can adjust an individual board address manually, and eachMCB can be controlled via the mass calibration software installedon the user’s computer. Individual configuration and calibration ofDUTs is possible by multiplexing the power supply of the DUTs.The serial interface used by the DUTs is adjusted automatically viasoftware. If more than one MCB is used simultaneously, then theseadjustments must be identical for proper operation.Jumper connectors on the MCBs provide access to all power lines.The board can be supplied with 8 to 16 VDC via the on-board 5Vlinear regulator. To avoid overloading this single power supply lineif heavy loads are driven, there are separate power supplyinterfaces for the MCB, the DUTs, and the I2C serial bus.